Fuse Instructions

"Thank you for your purchase of the most convenient and safe alternative for accessory connections at your fuse panel. You will be delighted with its convenience. Below are a few installation tips and suggestions. If you have any questions about the use of this product, please feel free to contact us at info@accessafuse.com "

1. Decide if you need a power source that is hot with the ignition key on or with the ignition key off. This will depend on what accessory you are going to add to your vehicle. Use a voltmeter or a test light to find the fuse that is hot with the key on or with the key off. 

2. Notice the color of the Access-A-Fuse (yellow). Now remove the same color fuse from your fuse panel that you previously tested with your test light or voltmeter.

3. Flip up the Accessory terminal (if it isn’t up already) on the Access-a-Fuse. Push your female spade connector onto the extended terminal. Now insert the Access-A-Fuse into the fuse slot where you previously removed a fuse. Make sure that the extended terminal is on the Load side of the fuse panel and not on the Feed side of the fuse panel. Don’t be confused!

Access-A-Fuse Warranty

At Access-A-Fuse, LLC, we take pride in the quality of our products, and your satisfaction with their performance. Thus, Access-A-Fuse, LLC warrants this product to be free from defects in material and workmanship under normal use and service. However, Access-A-Fuse, LLC will not be liable for any incidental or consequential damages and your exclusive remedy shall be replacement of the part(s) not meeting this limited warranty. Federal and/or state laws may provide you with other warranties for this product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.